|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
;
I got the manual quickly after the payment was transfered (1 day). The manual was exactly what i needed and the updates via e-mail were great. Thanx!
;
I've looked for this manual all over that internet, you guys had it and to a good price. A++++
;
I've looked some time for this manual, you guys had it and to a good price. A++++
Power Amplifier APPLICATIONS � BPx MODELS
To the right are several application diagrams to help plan your subwoofer system installation. Figures 1 through 3 show how to configure the JBL Power Series subwoofer amplifiers (models BPx500.1, BPx1100.1 and BPx2200.1) for 2-channel, bridged-mono and parallel-mono operation �Setting the utput Mode� on page 6). O NOTE: For simplicity, Figures 1 through 3 do not show power, remote and input connections. NOTE: If the nominal impedance of your speaker system is close to 2 ohms, be prepared to try both bridged and parallel configurations to determine which performs better.
Set OUTPUT MODE to 2CH/BR
(on input panel)
2 CHANNEL BRIDGED
BPX2200.1
CH 1
CH 2
PARALLEL
2CH/BR
BPx Amplifier
(partial rear panel)
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
X-OVER
FREQ
Figure 1. The JBL Power Series subwoofer amplifier is set to 2-channel mode to drive a pair of subwoofers.
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer
Subwoofer
Set OUTPUT MODE to 2CH/BR
(on input panel)
PARALLEL 2CH/BR
2 CHANNEL BRIDGED
CH 1
CH 2
BPx Amplifier
(partial rear panel)
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
Figure 2. The JBL Power Series subwoofer amplifier is set to bridged (mono) mode to drive a single subwoofer. Use this mode only when the nominal impedance of the speaker system is 2 ohms or greater.
X-OVER
FREQ
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer (2 ohms or greater)
Set OUTPUT MODE to PARALLEL
(on input panel)
PARALLEL 2CH/BR
2 CHANNEL BRIDGED
CH 1
CH 2
BPx Amplifier
(partial rear panel)
jumper
PARALLEL*
NEON
OUTPUT MODE
SPEAKER OUTPUTS
*SEE MANUAL FOR PARALLEL CONNECTION
Figure 3. The JBL Power Series subwoofer amplifier is set to parallel mode to drive a single subwoofer. Use this mode only when the nominal impedance of the speaker system is less than 2 ohms. NOTE: A jumper is added between the + terminals.
X-OVER
FREQ
32Hz 320Hz
12dB 24dB SLOPE
Subwoofer (less than 2 ohms)
4
|
|
|
> |
|
